Newbie here. I just finished putting together my 5 Pro a couple of days ago and successfully ran my first “project” with the “Hello World” file with the help of Will’s great instructions. (by the way, I got the 80 mm spindle which the pen holder adaptor does not fit. I used the 1/2 in collet and wrapped five rounds of painters tape around the sharpie pen and inserted that in the spindle and it worked great). My question is…is there a step by step guide to the steps needed to get a project started in CM. I have searched but could not find one. I would prefer to have a printed version at the machine that I can refer to until muscle memory kicks in.
This covers pretty much the entire process in fairly current software versions:
2 Likes
Thanks Will, by any chance is there a PDF version to print? If not, I will use what you posted. Much appreciated.
No PDF yet — we’ll see what we can work up.
1 Like
Thanks sounds good… Much appreciated
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.