Well it is a gift, just took 2 years to finish. Thought I would share.
Purchased my Nomad 2 years 9 months ago and out of all my shop equipment is gets the most use. I think I have bought 1/32 end mills from every vendor on the planet.
Cut on the nomad was:
Flowers 20 gauge - 1/32 end mill. Opaque vitreous enamel, 6/32 plusnut holding them together with a 3mm micro led inside it.
Hummingbird wing 14 gauge - 1/32nd end mill transparent vitreous enamel
Butterfly 14 gauge - 1/32nd end mill transparent vitreous enamel
Base black walnut created in carbide create pro on the nomad.
2 years 9 months ago I didn’t have a clue about any of this. It’s been a fun ride.
The Nomad, the software both carbide create and carbide motion and the support that goes with was awesome.
