Crash after bit change

[mhotchin (Michael Hotchin)]

Sounds similar to this:

**Never** Lower Z axis when travelling to BitSetter

If the Z axis is already higher than the normal height the Z is raised to when going to the BitSetter, it should not lower the Z. On the way back from the BitSetter, it should also raise to the height it travelled at, not just the default. I’m working with stock that is close to the max thickness I can fit on the machine. There is enough clearance for the job, however: [WIN_20250101_20_11_45_Pro] When I set my Z Zero, it immediately lowered into the stock with the result you see here. I i…