Cutting Parts using CM548, a BitZero, BitSetter, and BitRunner

[WillAdams (William Adams (Carbide 3D))]

and clip the ground lead in place:

For the specifics of using the BitZero see:

BitZero_V2_Shapeoko_Setup_User_Guide_03-08-2021_v1.pdf

https://docs.carbide3d.com/assembly/bitzero/userguide

Using/verifying the BitZero

Here is how I check out the functionality of the machine/BitZero: first check that you have sent the correct Z-axis configuration This can be easily done by jogging down to the wasteboard surface, setting zero, then using the Rapid Position command to lift 6mm above the current zero — measure how much the machine moved — if it’s wrong: go to the MDI and send $$ and check that the Z-axis steps/mm match your machine setup: Belt-drive: 40 Z-Plus: 200 HDZ: 320 ​ ​c.f., Then, clamp a sui…