Feed Hold Switch

[LiamN (Liam Newcombe)]

If the feed hold works the same as the older controller boards then;

Adding Feed Hold Switch with 12V Light - Voltage Step-up

Alright… before this thread closes, I want to spell out in detail how I did this. It wasn’t too complicated, but this way it’s documented. Feed hold, which will stop movement of spindle when activated, and resume when disengaged: [PXL_20200927_121237976] [PXL_20200927_121239968] *For this to work, you need to first have gone through the steps of @Julien’s topic here. (Minus the pendant if you do not want/need) Necessary preliminary actions: -Must use CNCjs for this -Must be using a Raspb…