How do you specify a contour toolpath to start from a specific location from outside your stock piece and then move in from there to a specific starting location of your contour toolpath to complete the cut?

Hello Tod1d, Thank you so much for your reply with all the detail and explanations about my request. You have provided valuable insight of CC capabilities I was not aware of and was not able to find from carbide’s documentation. I have created a test piece to try out your suggestions for cuts I’m …

How to choose a contour toolpath to start outside your stock

Software Carbide Create

WillAdams (William Adams (Carbide 3D)) May 14, 2025, 7:33pm 8

There are feeds and speeds for the #102, #102Z, and #274Z in aluminum in Carbide Create.

I’d recommend the latter as discussed in the videos listed at:

1 Like