I'm in the Game

[ApolloCrowe]

@KevBarn14
Game on!
Thanks for the kind words!
Heres my threaded table and clamp plans, I went right into the stock MDF, but attaching a secondary sheet is probably a better approach:

XL and XXL Threaded Insert table Grid and Clamps

Heres a few helpful Carbide Create files: Work holding Clamps and a threaded insert grid pattern (with recesses) for the XL and XXL Shapeoko machines. I was able to use the Makita router to cut the bed grid by flipping the collar upside down, which lets the router sit about .25" lower. By leaving the tool hanging out of the collet 1.75" you can get .65" deep into the wasteboard - just enough to drive the threaded inserts into the stock wasteboard. As always, test your perimeter and extents b…