Letter cutout, again

Hey again everyone. Still issues with getting this figured out. I’m not experienced with Inkscape.

The “M” is 9.35” from top left corner to bottom left corner. The “K” is 6.25” from top right corner to bottom right corner. Total length is 47.677”. I need to cutout each letter individually, but need a backer that is slightly larger and NOT cut individually, meaning it’s gonna need to be 47.677” long and the shapeoko xxl only carves 32”. Is this going to be possible?

Please, any insight or help figuring this out to an SVG would be greatly appreciated. Thank you.

16 posts were merged into an existing topic: Tiling this .c2d on shapeoko xxl help please!