Looking for modular shelf ideas

[WillAdams (William Adams (Carbide 3D))]

Each set may be selected:

Scaled:

Done

Adjust as desired until one arrives at a preview which seems promising:

Then I would suggest duplicating this file and editing it down so as to test on a small-scale and verifying the fit of the joinery and adjusting as need be.

Note in particular that if using a belt-drive machine, one will want to calibrate for belt-stretch:

Calibrating the machines over long distances

The typical technique for machine calibration: https://carbide3d.com/hub/faq/belt-stretch/ depends on precision measuring tools, and is limited by the reach of the tools in question. EDIT: It also depends on access to the MDI — if using Carbide Motion v6 it will be necessary to enable this in Settings | Options: [image] It should be possible to cut strips from a suitable blank of material, one along each axis — so we set up a square file which matches an available blank of material: [im…

Attached as a v874 file:

4x2_bookbox_full-blind_boxjoints.c2d (156 KB)