Losing position during cut

[WillAdams (William Adams (Carbide 3D))]

If everything checks out mechanically, prepare a small test file such as:

Diamond-Circle-Square Calibration file

The last one I posted: no longer opens properly in current versions of Carbide Create, so here is how to draw up and assign toolpaths to one. Begin by launching Carbide Create, going into Job Setup, and creating a 4" x 4" stock area with the origin set at the center: [image]

and let us know step-by-step how you are securing your stock, setting zero relative to it and managing all tool changes, and post photos showing how the cut turned out and the machine at the origin or a specified offset from that position and we will work through this with you.