WillAdams
November 14, 2021, 2:27pm
2
The settings for a Shapeoko 3 are noted at:
https://docs.carbide3d.com/software-faq/shapeoko-3-default-grbl-settings/
there was some discussion about more aggressive settings at:
Hey guys, I’ve been playing around with some modified GRBL settings for awhile now with the hopes of one day convincing Rob to open up the throttle a bit more on default machines. Please consider these “beta” settings, but if you’d like to test them on your Shapeoko I’d welcome any feedback.
Here are the parameters I’ve modified:
$25 = 1700 // Homing seek speed (for initial touch-off) that I run. If you haven’t flashed settings for your machine since 2018, you may be be at 1000mm/min which wou…
which were implemented. To see the specific settings open up the Log, then go to the MDI and send $$ to the machine, then check the Log for what your machine is set to.
1 Like