Randy
May 21, 2026, 2:03pm
21
I’m not sure I can remember back that far, Nathan.
2 Likes
nwilson
May 21, 2026, 5:09pm
22
Ok, I’m starting my writeup on single form threadmilling here:
A while ago, @HeuristicBishop generously sent me a few of the single form threadmills he had acquired. I asked no questions about how many he had, or why the supplier was out of stock… he only asked if I would do a writeup about the threadmilling process. I’m finally making good on that.
This will be a multi-part series as I do some chain-of-consciousness. I program in Fusion, I cut aluminum, and I’m no machinist but I did stay at a Holiday Inn Express that one time.
Part 1: What is threadmill…
If the job goes well today, it’ll have some cool photos by the end of the day. If I go quiet… well, either the job went south or the kids got home before I finished.
2 Likes
I’m turning 70 later this year. It is great, living in the future!