New Cutout toolpath in CC v8 Beta Build 853

[WillAdams (William Adams (Carbide 3D))]

The intention of the new Cutout toolpath is to allow cutting out parts without cutting deep slots without the added steps of offsetting geometry and cutting as a pocket down to tab height.

I showed using it here:

Recreating machine part from photo

And, now we have a scan: [MasiarzGasketFineLineScan_20260616_0001] As before, the file does not allow a direct 1:1 scaling, so we measure the grid at the current size by zooming in: [image]r and drawing a square: [image] [image] 12:1 seems a reasonable scale to try for, so we draw an 0.25" square: [image] then scale it up by 12: [image] [image] Done [image] and then adjust the image scaling to line up: [image] Again, we set the Job Setup to some dimensions to match: [i…

and wrote up a bit on it at:

Toolpaths | Design into 3D