New user - can't get it to work!

[WillAdams (William Adams (Carbide 3D))]

There are two notable configurations which need to be done:

• Carbide Create: be sure “Carbide 3D Shapeoko” is selected under Edit | Select post-processor
• Carbide Motion: enable and configure the BitSetter in the Setup Wizard

https://my.carbide3d.com/docs/shapeoko-setup/

For a walkthrough of a simple project in the current versions see:

Project from beginning to end in CC816 and CM644

as requested on support… First, measure your stock: [WIN_20250624_19_16_03_Pro] Then set up the Job as described in: https://carbide3d.com/hub/courses/create/job-setup/ Launch Carbide Create: [image] click on “Job Setup” [image] and fill in the desired parameters.