New xxl and setup

[MadeToBeMakers (Steve Coffman)]

Hello! We just received our xxl and set it up today. I have installed carbide motion and carbide create. When I start up Carbide motion to configure the machine like the manual says I don’t see the options for Shapeoko settings as shown. I have attached a screenshot of what my screen is showing me. Any help would be greatly appreciated!

Thank you

Steve

[WillAdams (William Adams (Carbide 3D))]

Please see:

Setting Grbl Configuration in CM 517 and later

Carbide Motion 517 uses a new system for setting Travel Dimensions which is potentially confusing: [image] Pressing the Load Defaults button takes one to a window which allows one to select first machine size: [image] and then Z-axis type: [image] after which selection the Travel Dimensions for the selections made are entered into the dialog and will be preserved if one clicks “Ok” (and of course that change discarded if one selects “Cancel”). In addition there is a “Send Configuration…

or see the ~14 min. mark of this video:

Shapeoko Pro Assembly Overview

[MadeToBeMakers (Steve Coffman)]

Thank you Will!! I will take a look at this now. Appreciate it!