Nomad vs. Shapeoko overall speed

[WillAdams (William Adams (Carbide 3D))]

A small project on my Nomad:

Help with vCarving a sign

Further adjust the paths, or use a tool which limits depths, or use a shallower angle tool, or a thicker material. I figure I’ll just fill w/ powdered enamel and epoxy. Anyway, finally found time to cut this w/ the right endmills: [image] Need to get a loupe from work and deburr the edges and then work out some way to infill the colours.

(about 3/4" of an inch high)