Not sure where I'm going wrong here - Juice groove

[WillAdams (William Adams (Carbide 3D))]

If the stock is accurately measured, and zero is accurately set, then that leaves calibration for belt stretch:

Calibrating the machines over long distances

The typical technique for machine calibration: https://carbide3d.com/hub/faq/belt-stretch/ depends on precision measuring tools, and is limited by the reach of the tools in question. EDIT: It also depends on access to the MDI — if using Carbide Motion v6 it will be necessary to enable this in Settings | Options: [image] It should be possible to cut strips from a suitable blank of material, one along each axis — so we set up a square file which matches an available blank of material: [im…

alternately, try using center, which if set accurately would evenly distribute any error so as to maintain a consistent placement.