Finally got around to install in the new spinderella. Couple very important things to note:
- There is a new revision from what I had originally. 1.1 v 1.0 board. The 1.1 board has Mini-Fit Jr 4 pin connectors where the old board had the wires directly soldered to the board.
- I had to use my rework station to remove the connectors, then reverse engineer the pin out and directly solder to the board since I didn’t have any connectors on hand. I would suggest that C3D either verify the version the customer has, or just ship the replacements with the connectors included.
The new board fixed my issues and I now have spindle control again.