Power supply and status lights

[Julien]

@Stardaddyed

Add LED lights to the cross beam (but nothing special). I will probably power them off the machines power but is it 12 or 24v? I would like the lights to come on when I power it up without having a separate switch if possible.

You can pick up the 24V off the controller as I did here but be sure to not draw too much, and be aware that this is not a supported mod.

@Stardaddyed

I would also like to add a light to indicate the machine status. I have a bitrunner so when it is ready for a new bit or finished I would like a light to indicate that it has stopped. Does anyone know of a way to trigger a relay for that?

Did you mean bitrunner or bitsetter ?
BitRunner reads the PWM signal from the controller, so you could in theory hook it up to a relay to light up a lamp, but you are in tinkering territory.
BitSetter triggers the controller’s probe input, so again in theory you could ready it, but it’s more tricky.
Overall I don’t think that second point of yours is going to be very easy to implement