PSA: Vcarve changes if you don't start at the surface top

[WillAdams (William Adams (Carbide 3D))]

That is a problem with the font.

See:

Fixing a problem in a font

as requested on support… … another small problem. Trying out vcarve and looks great but it does not cut the center of the e. The toolpaths in question: [image] are caused by the geometry self-intersecting. Draw in some geometry to define the intersection: [image] Then use Trim Vectors [image] [image] to remove the extraneous length: [image] OK [image] Then draw in geometry to define the next section which needs to be removed: [image] [image] Then use Trim Vectors to re…

It’s just that the deeper cutting depth brings out the problem.