Restarting where you left off - suggestion

[WillAdams (William Adams (Carbide 3D))]

@shelkol

Carbide Motion could be more efficient, IMHO it has too many popup windows and I find myself going back and forth between my remote keypad and the laptop keypad.

See:

Carbide Motion Beta with New BitSetter Workflow

It’s here, use it at your own risk: https://carbide3d.com/carbidemotion/beta/ With the better write up here: BitSetter Changes in Carbide Motion Let us know how it goes in this thread. PS- We went far enough in removing popups that even Winston, who values every second, was a little worried. Assume that any time you do anything to affect a Z zero, the machine will take off moving. We can always add warnings back in there, but we wanted to give minimum warnings a shot.

and the thread:

Likely Change to Carbide Motion

I wanted to share a change we will likely roll out to Carbide Motion soon. It’s something we’ve had on the drawing board for a long time, but we never wanted to make a breaking change to the workflow. CM will begin measuring the tool using BitSetter after you set a Z zero, whether by touching off or using a probe. It will no longer be necessary to load a tool and measure it when you initialize the machine. It will no longer be necessary to load a tool only when you press the “Load Tool” butto…

We are glad to have feature suggestions and constructive criticism.