Roundover on guitar body

[mojotron (Mike)]

I imagine that this topic comes up from time to time, but I have not seen a good thread on how to actually do it in CCv7 Pro. What I want to do is put a 3/16" roundover on a Telecaster guitar body using a rounded form with Carbide Create Pro. Does anyone know how to approach that, or perhaps a way to find out more about how to put a 90 degree rounded edge on an complex shape that has a depth of 3/16"?

Thanks in advance for any help.

[WillAdams (William Adams (Carbide 3D))]

See:

Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

These are usually used in routers for decorative effects in wood: https://www.whitesiderouterbits.com/products/1570 but they are potentially useful for joinery: They are also useful for rounding off parts to allow rotary motion as for a hinged lid. Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series o…