timrr
(Tim Robertson)
April 7, 2022, 8:18pm
1
Does anyone have a model or drawing for the hybrid table on the pro xxl? I am trying to make a waste board and I want to ensure I have the proper spacing between t-slots.
Thanks,
Tim
WillAdams
(William Adams (Carbide 3D))
April 7, 2022, 9:14pm
2
I posted the XXL slats at:
We cut the holes and do the math, and send the new values for $100 and $101, then re-cut the holes to verify — with the new holes both measuring at 99.99 we call it close enough.
Next, in CM move to the SW point and set XY origin there.
Then we load a drawing of the hybrid T-tracks:
[image]
Hybrid T-track slats - XXL.c2d (110.5 KB)
(it would be great if someone would measure the slats on a standard/XL size machine)
and simplify and rotate it and set the stock size to match the rapid posit…
The dimensions for the Hybrid T-tracks are at:
The main slot is approximately 17mm wide 10mm high. The slot is approximately 9mm wide and 4mm high and the T nuts are M6.
Very clear thank you very much, that certainly would be an easy solution.
As shown in green:
[GreenExtrusion]
system
(system)
Closed
May 7, 2022, 9:14pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.