Shapoko 4 XXL initial setup

[WillAdams (William Adams (Carbide 3D))]

Which size machine do you have? Which did you configure for?

It might be that either adjusting the position of the homing switch or calibrating for belt stretch will adjust this:

Calibrating the machines over long distances

The typical technique for machine calibration: https://carbide3d.com/hub/faq/belt-stretch/ depends on precision measuring tools, and is limited by the reach of the tools in question. EDIT: It also depends on access to the MDI — if using Carbide Motion v6 it will be necessary to enable this in Settings | Options: [image] It should be possible to cut strips from a suitable blank of material, one along each axis — so we set up a square file which matches an available blank of material: [im…