STL File imports but wont do anything

[WillAdams (William Adams (Carbide 3D))]

See:

Importing Crocodile STL and assigning toolpaths

Since this was first set up, Carbide Create v8 has been released, and the UI has changed somewhat. Install v8 per: which when launched appears as: [image] Given the requirement: cut out the 3d model to approximately 3/4 " thick with the base material or the material that is left under the image to at least 1/2" One would set up the file as: [image] which when converted into Imperial shows a thickness of 0.8276" [image] so we reduce the thickness to 0.75": [image] So we draw a…

and:

3D Tool - Import STL | Carbide 3D Guides

3D Toolpaths | Carbide 3D Guides

Toolpath Simulation | Carbide 3D Guides

If you’re still stuck, upload the .stl and .c2d (post them as links to a file sharing site if need be).