This here is the settings I used for the video and the finished part . Adaptive on the left finishing on the right, Will give you cold to the touch parts with no lube or chip fan in 6061 t6 . I have ran the machine up to its limit at 24k rpm but the machine is very very un happy at that speed, The difference between being completly maxxed out vs 22k rpm with those settings listed was only 43 minutes vs 46 minutes. At 24k rpm the spindle creates a nasty resonance( not visible in the part but just overall not fun to be around ). Endmill is just a standard #102 2 flute 1/8th inch ive been using as a feed testing endmill. Finish is better with tap magic as cutting fluid but you can end up with chip recutting unless you have an airblast.
