Tolerance in squaring machine during initial assembly

[WillAdams (William Adams (Carbide 3D))]

@QCDvacuum

file that contains an overlapping circle, triangle and square

Easier to find if you think of it using the traditional terms, “diamond, circle, and square”:

Diamond-Circle-Square Calibration file

The last one I posted: no longer opens properly in current versions of Carbide Create, so here is how to draw up and assign toolpaths to one. Begin by launching Carbide Create, going into Job Setup, and creating a 4" x 4" stock area with the origin set at the center: [image]