Could someone run through the process of defining a tool for use with Carbide Create. I know how to add tools but I’m looking to add an Amana Tool #56123 ( 56123-5 5 Pack Carbide Tipped Point Cutting Roundover 1/4 Radius x 1/2 Dia x 1/2 x 1/4 Shank Router Bit ) - I’m just not clear on what fields I…

I would probably enter this as a 0.030" - 0.032" diameter endmill. Just slightly larger than the point/tip radius (D1). And program my depth to 0.248" This leaves a few thousandths so the sharp edges of the tool are not leaving a line in the stock. [roundover_bit_diagram] It won’t look right i…

Tool Definition

Software Carbide Create

WillAdams (William Adams (Carbide 3D)) October 2, 2024, 10:40am 4

Please see:

1 Like