Toolpaths and bit changes

[mhotchin (Michael Hotchin)]

Do you have a BitSetter? It sounds like you don’t.

In that case, you would save the file with only the roundover toolpath enabled, and run that.

After it finishes, change the bit, re-zero on Z, and re-save the file with only the contour path, and run that.

Feat Req: CM warn if file has multiple tools, AND the BitSetter is not enabled

Saw yet another thread about “How do I re-zero my tools in a multi-tool cut”. Carbide Motion should warn the user if the BitSetter is disabled, AND a file with more than one tool used is loaded.