This is my first post on the community forum. As you can guess I am a newbie. I am trying to cut frets on a guitar fingerboard. It is laid out along the x axis. After doing a practice run on a scrap board, I am seeing that the frets near the nut end of the fingerboard (or left side of the board) are where they should be but as you move to the right the frets are progressively mislocated by as much 3/32” when you reach the 20th fret. I’m thinking about laying the fingerboard on the y axis to see if I get a different result. I would appreciate any feedback on what could be the problem. Thankis
See:
This topic was automatically closed after 30 days. New replies are no longer allowed.