Upgraded to build 636

[WillAdams (William Adams (Carbide 3D))]

@anchoruc6

Ok, so after removing the ground clip, and after the router returns to XY. I can go to running the program?

Yes, if the BitZero probing option set the zero where you want it to be.

@anchoruc6

Do i clear offsets before using bitzero?

If needed — why would that be necessary?

For a detailed overview on probing see:

Using/verifying the BitZero

When testing with the new Carbide Motion, things happen a bit differently, but the result is the same. Download 635 from: After installation, launch the program: [image] (if necessary, configure per: Shapeoko Machine Setup ) Connect: [image] Initialize: [image] and the machine will initialize and then move to the front. Clamp stock on the machine: [20240402_1759371] position the BitZero on it appropriately for the sort of probing which one wishes to do: [20240402_1802091] Ve…

and it may help to review:

https://my.carbide3d.com/gswso/06