Using carbide create 6 for stacked text

[WillAdams (William Adams (Carbide 3D))]

See:

Could use some guidance on creating a carve

To do this using the Advanced V carve features it’s much the same, just a bit simpler: Set the texts and duplicate them and set the duplicates aside in case a reference is needed: [image] draw up the V carving geometry in profile to see how things will cut: [image] and offset the top geometry by that distance: [image] [image] Boolean union w/ the outside geometry for the lower layer: [image] [image] Where geometry has been lost, bring back the geometry which was used by repeatin…

if you’re still stuck, please post your file as @mhotchin suggested.