What did you cut on your Shapeoko/ Nomad today?

[HeuristicBishop (Tyler Sowers)]

Strong recommendations for the downcutting vbits from cadence mfg over the years.
For example:

Less chipping in fine V-carves

Have you tried downcut V bits? I fond that they do an excellent job of preserving details. However, I usually have to run the V Carve a second time to clean up the bottom of the cut. Most V bits are shear cutting (cutting edge parallel to the shaft). The downcut V bits I use come from Cadence Manufacturing (Cody’s CNC): He has 30, 60 and 90 deg V bits, the Groovee Jenny series.

If the likes of @Tod1d and @mhotchin think they’re worth the $$, that’s what I’m reaching for first