Can’t wait to try this out. I’ve been on cncjs on rpi for a long time, wish there was still development there. Same experience with gSender, so much promise, too many bugs.
Is there a way to change the port so you could run alongside the cncjs install on an rpi? Or maybe there’s another way to go about that. Assuming if I install it will create a conflict with the cncjs install also using port 8000.
Here’s a post I wrote up a while back on the cncjs custom commands feature and using it to create rapid position locations. Would be a great feature in this. I wish you could assign a keyboard command, but I don’t think there is a way, like ctrl-shift-b to execute rapid move to back center and get the spindle out of the way. Looks like you may have this with the Rapid widget I saw in the video.
And agree with keyboard commands as well, I just setup a macropad with the cncjs commands. Works pretty well. If this works with a gamepad though, maybe even better (and something new to purchase…). Be a nice feature to have those keys customizable, couldn’t tell from the video if that was the case.