Cutting miters the naughty way

[WillAdams (William Adams (Carbide 3D))]

Carbide Create cannot do the toolpaths shown above in a simple fashion — you’d have to do something along the lines of:

Spoon Possible without CC Pro?

I’d like to make a wooden spoon and was wondering if that’s possible to do with the standard CC? Can it be done with a bowl bit? I don’t have one but can pick one up. Thanks!

I do 45 degree miters using a 90 degree V endmill:

A simpler sort of box, full blind miter, hidden box joints

Revisiting this — the simplification is reducing the amount of geometry necessary by using a large endmill to cut the miter at the corners — the tradeoff is one can’t clamp at the corners, and more stock will be cut away at them. Required tools: a small square endmill of a size which can cut completely through the stock a large V endmill which can cut significantly more than half-way through the stock a small/narrow V endmill which can be used to cut the V in-between the finger joints and the…