Machine Lost Coordinates During Cut

In the middle of my cut, it seems like my machine lost its coordinates. Has anyone seen this before? I’ve paused the job and when I go to resume, it wants to cut the next ornament in the wrong position. The workpiece did not shift.

Is there a way to reset the job at a certain line in the code?

CM: Build 618

I threw a few pictures below, if it would be useful to see the CC file let me know and I can upload it.



Best thing to do is to edit the file to match what needs to be cut yet and send that.

Note that it is best practice to avoid slotting — where possible avoid slotting and add geometry and cut as a pocket


and consider leaving a roughing clearance and taking a finishing pass.

1 Like

Looks like you lost steps. The Shapeoko and CM do not lose their place or at least where they think they are. If you machine loses steps this is the result. So take a look at your F&S and too aggressive change them.


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.