- the rectangle should remain a rectangle and allow corner treatments until one: node edits, uses it in a Boolean operation, resizes it
- This works for me in CC 474: draw rectangle (3x4), select it, change height to 6, Apply — note that the above applies, so this won’t work if the rectangle has been made not a rectangle
- This is a known problem and has been reported — if you have a sample file which exhibits this problem please send it in to us
- Carbide Create doesn’t support drilling operations — a feature should be at least 10% wider at its narrowest pass than the endmill used
- At this time Carbide Create converts geometry into polylines when performing Boolean operations — hopefully this will change in the future — if you have to do such I’d recommend using Inkscape, or, treating the result as a template and re-creating it with the curve tool — had to do that in: Design into 3D: Boxes: Magazine storage
2 Likes