My first inlay project

[WillAdams (William Adams (Carbide 3D))]

How could Carbide Motion know which moves are related to flat depth and which are not so as to ignore them?

I used Vectric Vcarve and its flat depth option for:

Help with vCarving a sign

Further adjust the paths, or use a tool which limits depths, or use a shallower angle tool, or a thicker material. I figure I’ll just fill w/ powdered enamel and epoxy. Anyway, finally found time to cut this w/ the right endmills: [image] Need to get a loupe from work and deburr the edges and then work out some way to infill the colours.

which was sent to my machine using Carbide Motion.