Rhino 8 file import to CC as dxf, properties of Rhino are gone

[WillAdams (William Adams (Carbide 3D))]

Export as an STL and import into Carbide Create Pro:

https://carbide3d.com/hub/courses/create-pro/3d-tool-import-stl/

see:

Importing an STL

as requested on support… given an STL: [image] to import this into Carbide Create Pro one would: set up a suitable size job: Job Setup [image] [image] draw geometry to define where the import will be centered: [image] switch to the model tab: [image] and Import STL: Introduction selecting the file in question: [image] and then selecting the desired face: [image] and setting other options as desired: [image] and confirming the 3D preview: [image] Done [image] If…

or

Making a guitar bridge for Carbide Create Pro

as requested on support… Given a file in Carbide Create which describes a guitar bridge: [image] there are a couple of different ways which this part could be made: draw up contour geometry and assign toolpaths to appropriate depths (note that this does not require Carbide Create Pro): Spoon Possible without CC Pro? model the design in a traditional CAD tool, export it as an STL and then import that STL into Carbide Create Pro and then cut that 3D model using Carbide Create Pro: Instru…