Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

[WillAdams (William Adams (Carbide 3D))]

These are usually used in routers for decorative effects in wood:

https://www.whitesiderouterbits.com/products/1570

but they are potentially useful for joinery:

Design into 3D: Boxes: Magazine storage

Next up is more boxes, this time for magazine storage — for my part I just cut open Fed Ex boxes: [WIN_20190912_14_02_59_Pro] But they’re not always available in a suitable size for typical magazines. There are a number of commercial options: So there is certainly precedent for wooden boxes — we’ll try for an inexpensive material, since this is going to be a fairly large project (sorry Nomad owners) — Luan Plywood is available at most home centers, usually as underlayment, a bit of care…

Radiused Box joints

Adjustable Modular Designs

They are also useful for rounding off parts to allow rotary motion as for a hinged lid.

Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series of V endmill cuts.

[WillAdams (William Adams (Carbide 3D))]

Another source for these is Amana:

Point Cutting Roundover Router Bits - Grooving Router Bits - Router Bits -...

which has the advantage of providing rather more detailed information, in particular the tip diameter:

which allows one to set up a tool w/o the need for a test cut.

[Dooryard (Steven Knox)]

I was looking at these the other day and with a simple properly spaced grid could make for a nice soft “pillowy” background effect. like a nice tray of milk buns or somehting

[WillAdams (William Adams (Carbide 3D))]

To get a preview of how the tool will cut, draw up such a tool in profile (or import the DXFs):

The tool drawn above is:

56142 Solid Carbide Point Cutting Roundover 1/16 Radius x 9/64 Dia x 7/32 x...

With a profile in place, it is simply a matter of matching up various V endmills at appropriate depths:

(depicted are 30, 60, 90, 120, and 150 degrees)

This also brings up the fact that one could make such cuts using a series of V endmill and then sand to the desired profile.

[WillAdams (William Adams (Carbide 3D))]

Once the geometry which we wish to use is drawn up:

we position various V endmills relative to it:

and then draw the line for the contour toolpaths:

and create a group for the V endmill toolpaths:

and then assign the various V endmill toolpaths cutting to the appropriate depths:

until one arrives at:

[WillAdams (William Adams (Carbide 3D))]

Here’s a lid which uses this technique:

three_dollar_box - lid - offset roundover.c2d (501.2 KB)

which can be used on:

As funny as a $3 dollar box

Revisiting for a hinged design — first, verify the concept by designing and cutting a prototype in Carbide Create, then going back and updating the 3D modeling. First consideration is size — want it to use 3 bamboo cutting boards: top bottom sides and front and back [image]

[WillAdams (William Adams (Carbide 3D))]

The fit and appearance of the lid w/ the roundover tooling is much better: