What did you cut on your Shapeoko/ Nomad today?

[WillAdams (William Adams (Carbide 3D))]

For folks curious about using roundover tooling, note that it is not supported by Carbide Create, so one has to take the cut on faith to a certain degree — a technique for getting an approximate preview is shown at:

Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

These are usually used in routers for decorative effects in wood: https://www.whitesiderouterbits.com/products/1570 but they are potentially useful for joinery: They are also useful for rounding off parts to allow rotary motion as for a hinged lid. Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series o…