Work Size Limit?

[87vetter (Wayne Bussert)]

Does Carbide Create Pro have a work size limitation?

Can Carbide Create Pro have the tile function?

Thanks

[WillAdams (William Adams (Carbide 3D))]

There’s an upper limit on stock size — but I doubt anyone has a machine which would be limited by that.

No tile function yet for Carbide Create, free or Pro — have to do it manually:

6 qts of oil in a 1 gal pail : TUTORIAL

I make wooden toys and thus cut lots of small pieces out of large panels of stock. Some of the patterns extend past the working length of the SO3, ex. 32” long panel (I cut a sheet of plywood into 9 pieces 32” long X 16” wide). The rubber band rifle I’m currently building has a length of about 28”. I need to cut the outline of the pattern in 2 cuts and the 2 cuts have to start at the middle of the pattern and extend towards one end and then continue from the middle and extend towards the other e…

Tiling questions/issues

Okay, let’s imagine I want to cut out a 14" tall letter “J” on my Nomad: [image] I would start by drawing an 8" or so square which defines where there overlap is going to be: [image] I would draw in some holes for registration pins: [image] I would then duplicate and drag the registration pins and square to define the balance of what needs to be cut: [image] Then I would adjust the part I want to cut out so that it’s better placed and offset it by a bit more than the diameter of the …

[87vetter (Wayne Bussert)]

The main question I was trying to get to is does Carbide Create allow / support a cutting area of 48" x 32"?

[Tod1d (Tod (with 1 'd'))]

Width & Height: 200", Thickness: 20"

Pretty big. But I’m currently working on a postprocessor for a bigger machine 236" x 118" x 59" (6000mm x 3000mm x 1500mm)

[Bozo (Bozo T Clown)]

I actively use CC 729, CM 566? for ~ 57" x 32" cutting area, no problem.