Https://community.carbide3d.com/t/hand-held-controller/65894

[WillAdams (William Adams (Carbide 3D))]

You can use a numeric keypad:

Keyboard Shortcut Cheat sheet for Carbide Create and Motion

Hope this helps! [Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6] Updated version for Carbide Motion 5 (note that keyboard shortcuts have not changed for CM6) and Carbide Create 6 (updated for 627): Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6.pdf (665.0 KB) For folks who only use Carbide Create or Motion: Carbide3D_create_motion_keyboard_shortcuts_CM5.pdf (661.1 KB) — as noted above, this still works for CM6 Carbide3D_create_motion_keyboard_shortcuts_CC6.pdf (573.3 KB) and Car…

or a game controller:

Using a Game Controller with CM513 and later

Unfortunately, my son left his at college, so I haven’t been able to test this until now (picked up one while doing a run for essentials since it caught my eye): Picked up a: (since apparently that is what was used for testing, and I don’t want to trouble over another battery to charge) Only supported on Windows at this time. Initial setup requires plugging it in, and allowing the device to get setup. Controls are active when in Jog mode: Increment: RB — increases current jog rate RT — …

or game pad:

A different sort of pendant

I find the game controller and numeric keypad layouts a bit confusing (also, my son lay claim to the second Logitech F310 since he left his at college), and while I love the click on my wonderful 6 Key Keyboard (Techkeys SixKeyBoard CNC Edition) I find I need to change the jog rate often enough when using my Shapeoko that it has been consigned to the far corner of the basement for use with my Nomad (and I am anxiously awaiting the 3x3 version). Until that time, I’ve been looking for an alternat…

or a custom device:

NineKeyBoard CNC Edition