New to Carbide - Using Solidworks - Single cut question

[WillAdams (William Adams (Carbide 3D))]

FWIW, this would be quite simple to draw in Carbide Create if one had a dimensioned drawing:

Oar holder project

have been asked to help with an oar holder project. Here is the part that I would like to use CC to design and then cutout. Using this to learn…much more complex than what i have previously done. Not totally sure how to start. Maybe start with Create Curve and then the note editor??? Just looking for basic direction. tx. [oar holder layout]

Designing a Closet Shoe Rack with manual Tiling

as requested on support… … some cabinet side pieces that I’d like to use for a shoe rack. Would like some help on how to draw and cut the angled dadoes in the sides of the cabinet. Would also like some guidance on tiling these pieces as they are 8’ long. Everything is 3/4" Baltic Birch and I believe the depth will be 15". This is pretty straight-forward. Set the stock: [image] [image] Draw in geometry for the side cuts — this can either be done as continuous (if one is using Carbide Cr…

or:

Re-drawing parts from SketchUp

as requested on support… Given a design: [file] we first draw a circle with the specified radius: [image] and center it in a suitable working area: [image] Then import the pixel image for reference: [image] adjusting as needed: [image] Then draw in the rest of the geometry using the specified dimensions: [image] [image] Centering as needed: [image] [image] [image] [image] With all the dimensions marked out, select the circles, copy-paste them into place: [image] a…