Strange result in Simulations of modeled components

[WillAdams (William Adams (Carbide 3D))]

Upload your .c2d file?

I usually offset around a 3D part by endmill diameter plus 10%, see:

Making a guitar bridge for Carbide Create Pro

as requested on support… Given a file in Carbide Create which describes a guitar bridge: [image] there are a couple of different ways which this part could be made: draw up contour geometry and assign toolpaths to appropriate depths (note that this does not require Carbide Create Pro): Spoon Possible without CC Pro? model the design in a traditional CAD tool, export it as an STL and then import that STL into Carbide Create Pro and then cut that 3D model using Carbide Create Pro: Instru…