Learning Carbide Create 3d

[WillAdams (William Adams (Carbide 3D))]

You will need a Pro license:

Carbide Create Pro

and we have video training at:

https://my.carbide3d.com/carbide-create-course/

and

https://my.carbide3d.com/carbide-create-pro-course/

and I’ve written a bit at:

2D Drawing

and

Toolpaths

and

3D Modeling from 2D Geometry

and also see:

Tips and tricks for Carbide Create

There have been a couple of instances of folks asking for things in CC which are already present. To that end, this thread will be a collection of tips and tricks and shortcuts.

Keyboard Shortcut Cheat sheet for Carbide Create and Motion

Hope this helps! [Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6] Updated version for Carbide Motion 5 and Carbide Create 6 (updated for 627): Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6.pdf (665.0 KB) For folks who only use Carbide Create or Motion: Carbide3D_create_motion_keyboard_shortcuts_CM5.pdf (661.1 KB) Carbide3D_create_motion_keyboard_shortcuts_CC6.pdf (573.3 KB) and Carbide Create build 727 adds a number of keyboard shortcuts, so warrants its own chart: [Carbide3D_…

Instructions on How To 3D Carve using CC V7 Pro

First, configure the stock: [image] Draw in the geometry for the bowl and place as desired: [image] Inset by the desired width of the rim of the bowl: [image] [image] Offset to the outside of the bowl by endmill diameter plus 10%: [image] [image] Draw in geometry to define the stock (since we’ll be working subtractively): [image] Go to the 3D model tab and model the stock: [image] Select the geometry for the inner curve of the bowl and model it: [image] [image] Then im…

Trial Ver 432 3D carving Not finding much info other than a Star

Needing a little help with what Carbide Create can do and what it can’t do. Seems any videos I find and even in this site are all done with Vcarve software or fusion360. Can Carbide Create carve from an image like “Mikes” lighthouse? or a horse. Also I am using a Mac. Thanks for any insight

Vcarve pro wide flutes

Does anyone know of it is possible to create wide flutes similar to what are in the photograph with vcarve pro? [image]

Carbide Create Pro 3D tutorial --- small game board piece

A replacement for a lost board game part — first draw up the part, measure it, select an appropriate piece of stock and set up Carbide Create to match: [image]

3D Model - Creating a Ramp object

I either need some guidance, or I am requesting a new 3D modeling feature for Carbide Create. Built into Carbide Create is the ability to model Flat, Round, and Angle. In the screen shot below the top object is the classic “Angle” which produces a pyramid shape. What I want is (what I am calling) a “Ramp” shape, like the 2nd and 3rd objects below. Ramps angled horizontally or vertically. A “Ramp” is almost the same thing as an “Angle” object, but the height just varies on two sides instead …

Carbide Create Pro wavy flag

Arriving at: [image]

Modeling a bowl in Carbide Create

Designing a bowl: [image] which is: First, set the stock size: [image]